This small capture screw is designed to be installed in the capture slot of a .100" thick wedge key. Install it as close to the head of the wedge key as possible. If your slot is the correct length it should allow the wedge key to be drifted to clear the underlug, but prevent the key from being completely removed from the stock. Use one per wedge key.

The pin is .050" diameter with a wood screw thread on the upper third. Drill a 1/16" pilot hole to allow the threads to engage the wood during installation with a screwdriver.

We recommend this screw for use with:

• #KEY-36-B wedge key, straight head, wax cast brass
• #KEY-36-I wedge key, straight head, wax cast steel
• #KEY-36--S-B wedge key, slant head, wax cast brass
• #KEY-36--S-I wedge key, slant head, wax cast steel